Water purifier installation steps

Installation steps of pure water machine:

Close the tap water main switch, remove the faucet, connect the water inlet tee in the part package to the 1/4" plating ball valve at the side hole, and connect the 1/4" PE tube at the outlet of the plating ball valve. In addition, the faucet that was originally removed is directly taken back, and the other end is connected back to the original water source. At the faucet near the faucet, drill a hole through the PE pipe of the inlet water, then connect the PE pipe through the plated ball valve and pass through the drilled hole, and pull the PE pipe to the RO in the kitchen (such as flow Inside the cabinet under the platform, and connected to the water inlet of the host. After the pipe is connected to the hole, the glue is required to prevent the water from entering the flow table. Connect the 1/4" PE pipe to the drain port and introduce it into the drain of the flow table (the drain pipe must be drilled for a small hole to be inserted into the PE pipe). Drill a small 11mm hole in the appropriate place on the flow table. Then, install the gooseneck faucet, connect the 1/4′′ PE tube at the lower end of the gooseneck faucet, and connect the PE tube to the RO machine and place the activated carbon outlet. If you need to fix the gooseneck faucet on the wall, you can use stainless steel gooseneck slats without drilling holes in the counter. Connect the pressure tank to the pressure tank ball valve and the 1/4′′ water pipe joint, then connect the 1/4′′ PE pipe, and the other end of the pipe is connected to the three-way joint of the RO engine's activated carbon inlet. Fold the front three filter elements and install the filter case according to the corresponding mark. Remove the inlet pipe of the RO membrane tube and insert it into a container, open the water source and plug in the power supply so that the three pre-treated filter shells are completely filled with water and the activated carbon powder is dissolved in the water to flow out. Temporarily turn off the power, then replace the removed RO inlet pipe, and the installation is complete.